However, just listening to the record player through a normal amp, I realized quickly that I had a problem: Near the end of every record the last few tracks of it were distorting (or peaking) out. This made the vinyl highly unlistenable and basically negated the entire reason that I was assembling this system in the first place.
So after researching the issue, I discovered that it was due to the needle being unbalanced on the player. Basically, if the needle side is too heavy, it causes too much pressure on the record and results in distortion. Consequently, if it's too light, it causes record skipping and the needle doesn't stay in the groove. This problem generally does not become apparent until you reach the last few songs on the record due to the reach and pressure of the arm being maximized.
The solution to this is needle calibration, basically adjusting the weight on the needle end of the record player. This is easy on higher end record players and only requires a few clicks on the needle arm, however on midlevel record players it's a bit harder and requires measuring and highly technical readjusting. The problem? Although the LP-60 is an introductory model, it does NOT let you calibrate the needle on it, the only factory suggested way to fix this problem is to ship it back, and let them fix it. Being impatient and having zero clue if I voided the factory warranty by adding a new needle, I elected to fix the problem myself.
The problem is one of balance of the needle, so if it is too heavy.... simply counterbalance it. There is room behind the pivot point of the arm to do this afterall. Yes, it does look a little redneck, but I'm concerned very little with aesthetics and only after sound quality with this project. So to accomplish this counterbalance, I used a variety of objects, but most of them fell off.... until I tried the change from my pocket.
Now the balance issue will be different for everyone, I tried every setup from two quarters (which was MUCH too heavy) to a dime (which was much too light). This easiest way to do this process is to find a non-aggressive sounding album (think Bob Dylan, early Tom Waits) that doesn't contain big, distorted sounds. This way you will tell very easy if the weight is not correct due to the distortion being EASILY detectable. Start the record, then skip it to the last song of that side and listen to it as that is where the problem will be most apparent. If it's skipping around, you have too much counter-balance weight, if it's still distorted, not enough. (It should be noted this isn't particularly good for the record that you are playing, so DO NOT attempt this with a high-value, irreplaceable record).
I found my desired weight after a few hours of tinkering, which ended up being one penny placed as far forward on the platform as it would allow. This was adequate for clearing the record-player cover as well as the arm moving around the enclosure. I added a piece of tape and secured it. Now? My records sound amazing, and I'm ready to start building out the rest of my new HIFI system....Next up? DIY tube pre-amp.
